Cannot Interrupt Audio Message

[Neurotec]

Not sure if this is an installation issue or a features issue but I have 2 Multi-Choice options that I would like to interupt or end the audio file being played. Option one is leave a message but it doesn't take effect until after the audio messages is complete..about another 10 seconds.....Option 2 is replay and same problem.

Oh..... and changing Caller ID in Survey seems to have no effect.

Fantastic work by the way. Very impressive features.

[areski]

You should be able to set the CallerID on the campaign, this works for most of the user.
If you have issue with CallerID I will advice to run capture and investigate with your carrier.

MultiChoice, this should stop the audio once any of the valid key is pressed. You can define those keys in the branching section.

Thanks for your kind words, we are pleased to see the community growing and more users appreciating our work

Yours,
/Areski

[Neurotec]

I believe I have found what is causing our incoming DTMF problem. Apparently it is related to the G729 codec which is the Australian standard. So, we are using the GSM codec in the meantime. Can anyone assist with how I install the G729 codec into Freeswitch/Newfies. I tried one method but we had to buy a license which never worked and consequently broke our Dialler.

[areski]

This might not be the right place for this question as this is related to the configuration of FreeSWITCH itself, I will advice to go and look at the FreeSWITCH wiki.

Our company provides support if you need someone to help you with this : newfies-dialer@star2billing.com

Yours,
/Areski

[Neurotec]

This might not be the right place for this question as this is related to the configuration of FreeSWITCH itself, I will advice to go and look at the FreeSWITCH wiki.

Our company provides support if you need someone to help you with this : newfies-dialer@star2billing.com

Yours,
/Areski

Ah, yes of course. No worries. Thanks anyway.